Falcon U109988 - 02 manual Positioning the Cooker, Unpacking the Cooker, Moving the Cooker

Page 21

INSTALLATION

Check the appliance is electrically safe when you have finished.

Positioning the Cooker

Fig.6-1shows the minimum recommended distance from the cooker to nearby surfaces.

The cooker should not be placed on a base.

The hotplate surround should be level with, or above, any adjacent work surface. A gap of 75mm should be left between each side of the cooker ABOVE the hotplate level and any adjacent vertical surface.

For non-combustible surfaces (such as unpainted metal or ceramic tiles), this can be reduced to 25mm. A minimum space of 650mm is required between the top of the hob and a horizontal combustible surface.

Fig.6-2shows the suggested clearances above the cooker.

*Any cooker hood should be installed in accordance with the hood manufacturer’s instructions.

Surfaces of furniture and walls at the sides and rear of the appliance should be heat, splash and steam resistant. Certain types of vinyl or laminate kitchen furniture are particularly prone to heat damage and discolouration. We cannot accept responsibility for damage caused by normal use of the cooker to any material that de-laminates or discolours at temperatures less than 65°C above room temperature.

We recommend a gap of 920mm between units to allow for moving the cooker. Do not box the cooker in – it must be possible to move the cooker in and out for cleaning and servicing.

A clearance of 130mm is required if the cooker is near a corner of the kitchen, to allow the oven doors to open (Fig.6-3). The actual opening of the doors is slightly less, but this allows for some protection of your hand as you open the door.

Unpacking the Cooker

Do not take any packaging off the cooker until it is directly in front of the place in which it is to be installed (unless it will not fit through a door in its outer packaging).

Cut the banding straps and lift the cardboard box off the cooker, leaving the cooker standing on the base packaging. See the loose unpacking sheet.

ArtNo.090-0008 - 90 6BC cooker min spacing

Fig.6-1

����

 

����

���

�����

���

 

���

 

���������

���������

Fig.6-2

����������

ArtNo.090-0017 - 90 6BC min positions above cooker

���������

��������

Fig.6-3

���������

ArtNo.090-0024 - 90 induction door clearances

Moving the Cooker

Fig.6-4

On no account try and move the cooker while it is plugged into the electricity supply.

The cooker is very heavy, so take great care.

We recommend two people manoeuvre the cooker. Ensure that the floor covering is firmly fixed, or removed to prevent it being disturbed when moving the cooker around. To help you, there are two levelling rollers at the back and two screw- down levelling feet at the front. You will need the levelling tool.

From the back, tilt the cooker forward and remove the rear half of the polystyrene base pack (Fig.6-4). Repeat from the front and remove the front half of the poly base.

ArtNo.010-0001 Removing the packaging

19

Image 21
Contents User Guide Contents Personal Safety Installation and MaintenanceBefore You Start VentilationHob Care CleaningCooker Care  do not use the hob surface as a cutting boardHob Cooker OverviewResidual Heat Indicator, H Pan DetectorAutomatic Heat-up, a Child Lock, L Glide-out GrillPan Protection Function 0Fig.2-8Ovens  Never close the grill door when the grill is onLeft-Hand Multi-function Oven Multi-function oven functionsFanned grilling Fan ovenFan assisted oven Conventional oven top and base heatOperating the Ovens Right-hand tall ovenTo start and then stop the left-hand oven using the Timer Setting the time of dayClock Minute MinderAuto is showing, but you want to revert to manual cooking AccessoriesKey Lock Oven Shelves Left-hand Main OvenMain Oven Light Oven shelves Right-hand Tall OvenHandyrack Main Oven Tips on Cooking with the Timer Cooking TipsGeneral Oven Tips Cleaning Spills Cleaning Your CookerCleaning Burned-on Spills Daily CareControl Panel and Doors ‘Cook & Clean’ PanelsTall Oven Removing the Panels to clean the Enamel InteriorTroubleshooting Timed oven is not coming on when automatic cooking Timed oven is not coming on when turned on manuallyOven temperature getting hotter as the cooker gets older Food is cooking too slowly, too quickly, or burningDear Installer InstallationSafety Requirements Provision of VentilationPositioning the Cooker Unpacking the CookerMoving the Cooker Repositioning the Cooker following Connection Completing the MoveLevelling Fitting the HandlesElectrical Connection Fitting the Splashback optionalHob Check Grill CheckServicing To Remove Grill Element To Adjust an Oven Door AngleTo Replace an Oven Door  The door is heavy, so take careTo Replace the Tall Oven Door Outer Panel To Adjust the Main Oven Door Catch KeepTo Change the Main Oven Door Latch To Replace an Oven Door SealTo Replace an Oven Fan To Remove the Left-hand Oven Bottom and Top ElementsTo Change Oven Light Bulb Circuit Diagram Oven KeyCode Description Colour Code Circuit Diagram Hob Technical Data DimensionsConnections Français Avant de commencer… Installation et EntretienOdeur de neuf Sécurité personnelleNettoyage Français Conseils relatifs à la table de cuissonTable de cuisson Vue d’ensemble de la CuisinièreDétection de récipient de cuisson Indicateur de chaleur résiduelle, HTableau Chauffage automatique, a Verrouillage sécurité enfants, LProtection de récipient de cuisson Fours Gril Coulissant Glide-outFour gauche Fonctions du four multifonctionsFour ventilé Gril ventiléFour ventilé mixte Fonctionnement des fours Four droitRéglage de l’heure HorlogeMinuterie Arrêt automatique du four gaucheGrilles de four Four gauche four principal Fonction de verrouillageActivation de la fonction de verrouillage Désactivation de la fonction de verrouillageEclairage du Four Grilles de four Four droit four hautHandyrack Conseils généraux pour la cuisson au four Conseils pour la CuissonInformations importantes Nettoyage de la CuisinièreEntretien Quotidien Nettoyage des Déversements AccidentelsNettoyage des Déversements Brûlés Gril CoulissantPanneau de Commande et Portes Four HautPanneaux autonettoyants Dépannage La cuisson au four n’est pas uniforme Le four ne s’allume pas’éclairage du four ne fonctionne pas Emplacement de la Cuisinière ’intention de l’installateurPrescriptions de Sécurité Positionnement de la CuisinièreDéballage de la Cuisinière Déplacement de la CuisinièrePositionnement Final Abaissement des Deux Galets ArrièreRepositionnement de la Cuisinière après Raccordement Mise à NiveauRaccordement Électrique Montage des poignéesContrôle de la Table de Cuisson Contrôle du grilEntretien Remplacement d’un élément de table de cuissonRemplacement d’un thermostat Remplacement de l’interrupteur d’éclairageRemplacement d’un regulateur de gril Remplacement d’une porte de fourRemplacement du verrouillage de porte principale de four Remplacement d’un joint de porte de four19. Dépose d’un protecteur thermique d’element de four 20. Dépose de la partie arriere interne du four Remplacement de l’ampoule d’éclairage du four21. Dépose de l’element du four ventile 22. Dépose du ventilateur du fourSchéma de câblage Fours LégendeCode Elément Couleur Schéma de câblage Table de cuisson Raccordments Fiche techniquePuissances ElectricitéArtNo.000-0001 Aga address block