Falcon U109988 - 02 To Replace the Tall Oven Door Outer Panel, To Change the Main Oven Door Latch

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

Fig.7-7

������������

�������

ArtNo.320-0029 - Thermodial

14.To Replace the Tall Oven Door Outer Panel

Remove the oven door (see 11). Lay the door face down on a suitable surface and remove the two screws from the bottom edge of the door and the two screws from the inside face of the door.

Remove the outer door panel. Remove the handle by unscrewing the two screws.

Unscrew the two cross-headed screws holding the door handle fixing bracket to the door panel. Fit the door handle bracket and door handle to the new panel.

Fit the panel to the door and reassemble in the reverse order.

Fig.7-8	ArtNo.320-0004 Oven	Fig.7-9	15. To Change the Main Oven Door Latch
			Remove the outer door panel (see 13). Remove screws ‘B’ that
			hold the latch assembly to the inner door panel (Fig.7-8). Fit
			the new catch and reassemble in reverse order.
			Verify the door operation.

�

ArtNo.320-0003 Oven door latch

16.To Adjust the Main Oven Door Catch Keep

Open the oven door, and slacken off the locknut at the base of the keep (Fig.7-9). Screw in or out as required until the required fit is obtained. Retighten the locking nut.

Fig.7-1017. To Replace the Tall oven Magnetic Latch

Remove the control panel (see 1). Remove the plinth

(3 screws) and the central vertical cover (5 screws). Prise the retaining clip off the magnet unit.

Fit the new unit and retaining clip, and reassemble in reverse order. Check that the door operates correctly.

ArtNo.320-0005 Oven door rubber seal

Fig.7-11

ArtNo.320-0020 Oven back fixing screws

18.To Replace an Oven Door Seal

Open the oven door. The seal has small hooks that hold it in place by locating into holes in the rear door face on the main oven and oven front face on tall oven. At the corner, pull the seal diagonally away from the door centre until the hook is released (Fig.7-10). Proceed to the next hook and release it in a similar way, and so on.

You can use force if the hooks are stiff, as the old seal will be discarded.

Carefully lift away the inner back. Reassemble in reverse order making sure that the four screws and washers are fully tightened.

19.To Remove an Oven Element Thermal Cut-out

Disconnect from electricity supply.

Pull the cooker forward to gain access to the cover box. Undo the cover screws and lift clear. The cut-out is located on the earth plate beside the oven element connections. Disconnect the cut-out wiring. Undo the fixings that secure the cut-out to the earth plate and remove. Fit the replacement control and re-assemble in reverse order.

20.To Remove an Oven Inner Back

Disconnect from electricity supply.

Open the door and remove the shelves. Remove the screws and washers securing the inner back to the back of the oven (Fig.7-11). Carefully lift away the inner back. Reassemble in reverse order making sure that the screws and washers are fully tightened.

24