Craftsman 316.29271 manual Recommended Fuel Type, Fueling the Unit

Page 9

OIL AND FUEL INFORMATION

RECOMMENDED FUEL TYPE

Old fuel is the primary reason for improper unit performance. Be sure to use fresh, clean, unleaded gasoline.

NOTE: This is a four cycle engine. In order to avoid damage to the unit, do not mix oil with gasoline.

Definition of Blended Fuels

Today's fuels are often a blend of gasoline and oxygenates such as ethanol, methanol or MTBE (ether). Alcohol-blended fuel absorbs water. As little as 1% water in the fuel can make fuel form acids when stored. When using alcohol-blended fuel, use fresh fuel that is less than 60 days old.

Using Blended Fuels

If you choose to use a blended fuel, or if its use is unavoidable, follow recommended precautions:

Always use fresh unleaded gasoline

Use Craftsman Fuel Stabilizer or an equivalent

Drain tank and run the engine dry before storing unit

Using Fuel Additives

The use of fuel additives, such as Craftsman Fuel Stabilizer or an equivalent, will inhibit corrosion and minimize the formation of gum deposits. Using a fuel additive can keep fuel from forming harmful deposits in the carburetor for up to six (6) months. Add 0.8 oz.

(23 ml.) of fuel additive per gallon of fuel to an approved gas container according to the instructions on the container. NEVER add fuel additives directly to the unit's gas tank.

FUELING THE UNIT

NOTE: Fill or add fuel to the tank only when the cultivator is in a horizontal position (Fig. 9).

1.Remove fuel cap. Remove the tag from the fuel tank neck.

2.Place spout of gas container into the fill hole on the fuel tank and fill tank.

NOTE: Do not overfill tank.

3.Wipe up any gasoline that may have spilled.

4.Reinstall the fuel cap.

5.Move the unit at least 30 ft. (9.1 m) from the fueling source and site before starting the engine.

NOTE: Dispose of the old gasoline in accordance to

Federal, State and Local regulations.

Fuel Cap

Fig. 9

WARNING: Gasoline is extremely

flammable. Ignited Vapors may explode. Always stop the engine and allow it to cool before filling the fuel tank. Do not smoke while filling the tank. Keep sparks and open flames at a distance from the area.

WARNING: Remove fuel cap slowly to avoid injury

from fuel spray. Never operate the unit without the fuel cap securely in place.

WARNING: Add fuel in a clean, well ventilated

outdoor area. Wipe up any spilled fuel immediately. Avoid creating a source of ignition for spilt fuel. Do not start the engine until fuel vapors dissipate.

9

Image 9 Contents
Cultivator / Edger Table of Contents WarrantyIntroduction California Proposition 65 WarningSafety Warnings for GAS Units Important Safety InstructionsRules for Safe Operation Before OperatingOther Safety Warnings Save These InstructionsWhile Operating Safety and International Symbols Symbol Meaning Choke Control Know Your Cultivator Know Your UnitAdjusting Tine Depth Assembly InstructionsPositioning the Handlebars Attaching the Edger Wheel and BladeOIL and Fuel Information Recommended OIL TypeAdding OIL to Crankcase Initial USE Fueling the Unit Recommended Fuel TypeSTARTING/STOPPING Instructions Starting InstructionsStopping Instructions Operating Tips Operating InstructionsTransporting the Unit Never pick-up or carry the unit while the engine is runningFrequency Maintenance Required Refer to Maintenance and Repair InstructionsTine Removal and Replacement Maintenance ScheduleChecking the OIL Level Changing the OILHandling the unit Carburetor Adjustment AIR Filter MaintenanceSpark Arrestor Maintenance Replacing the Spark PlugElectrodes. Grit in the engine could damage the cylinder Storage Cleaning the UnitLong Term Storage TransportingTroubleshooting Remove the rocker arm cover and gasket Rocker ARM ClearanceIntake Exhaust Specifications EngineCultivator Page Your Warranty Rights and Obligations Owner’s Warranty ResponsibilitiesManufacturer’s Warranty Coverage Cultivadora / Bordeadora Garantia IntroduccionIndice DE Contenidos Proposición 65 DE CaliforniaAdvertencia Laes muygasolina Importante Informacion DE SeguridadNormas Para UNA Operacion Segura Lea Todas las Instrucciones Antest DE LA OperaciónConserve Estas Instrucciones Durante la OperaciónOtras Advertencias de Seguridad Advertencia Los Advertencia NoAdvertencia Simbolos DE Seguridad DE IntercacionalesConozca SU Unidad Conozca SU UnidadAplicacion Colocación DEL Manubrio Instrucciones DE EnsambleAjuste DE LA Profundidad Conexión DE LA Rueda Y DE LA Cuchilla DE LA BordeadoraInformacion DEL Aceite Y DEL Combustible Advertencia EL LlenarTipo DE Aceite Recomendado Carga E Aceite EN EL Carter DEL Cigüeñal USO InicialAdvertencia Saque la Advertencia Lagasolina esAdvertencia Cargue el Tipo DE Combustible RecomendadoInstrucciones DE Arranque Y Apagado Advertencia Evite losInstrucciones DE Arranque Instrucciones DE ApagadoAdvertencia graves Advertencia formaAdvertencia evitarPara Advertencia Para evitarPrograma DE Mantenimiento Instrucciones DE Mantenimiento Y ReparacionFrecuencia Mantenimiento Requerido Consulte Remoción Y Reposición DE LAS PuasPrecaucion Use guantes Precaucion Para evitarInspección DEL Nivel DE Aceite Cambio DEL AceiteAjuste DEL Carburador Mantenimiento DEL Filtro DE AireLimpieza del filtro de aire Inspección del CombustiblePrecaucion No limpie Mantenimiento DEL Amortiguador DE ChispasCambio de la Bujía de Encendido Almacenamiento TransporteLimpieza de la Unidad EL Motor no Arranca Resolucion DE ProblemasEL Motor no Funciona EN Minima EL Motor no AceleraHuelgo DEL Brazo Oscilante Entrada Especificaciones MotorEJE Impulsor Y Cultivador Parts List Engine Parts Model Sears Cultivator 4-CYCLE GAS Cultivator 753-04059 Clevis Pin Cobertura de la Garantía del Fabricante Responsabilidades del Propietario para la GarantiáRepair Protection Agreements Get it fixed, at your home or ours