Connecting the System
Connecting the power cord (2)
Speed detection circuit lead
Vehicle injection Connector computer
Connection method
Pass the extension cord and the lead for the speed detection circuit through this hole.
Clamp firmly with needle- nosed pliers.
Close the cover.
Pink (CAR SPEED SIGNAL INPUT)
The mobile navigation system is connected here to detect the distance the vehicle travels. Always connect the vehicle’s speed detection circuit or the
IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELECTRICAL SHOCK, AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE’S ANTILOCK BRAKING SYSTEM, AUTOMATIC TRANSMISSION AND SPEEDOMETER INDICATION.
•It is strongly suggested that the speed pulse wire be connected for accuracy of navigation and better performance of interlock.
•If the speed pulse wire is unavailable for some reason, it is recommended that the pulse generator
Notes:
•The position of the speed detection circuit and the position of the parking brake switch vary depending on the vehicle model. For details, consult your authorized Pioneer dealer or an installation professional.
•Even when the light green lead and the pink lead are connected correctly, a message indicating improper connection is shown until sensor initialization has completed.
Light green
Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. If this connection is made incorrectly or omitted, certain functions of your navigation system will be unusable.
LIGHT GREEN LEAD AT POWER CONNECTOR IS DESIGNED TO DETECT PARKED STATUS AND MUST BE CONNECTED TO THE POWER SUPPLY SIDE OF THE PARKING BRAKE SWITCH. IMPROPER CONNECTION OR USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.
Connection method
Clamp the parking brake switch power supply side lead.
Clamp firmly with 
Power supply side
Ground side
Parking brake switch
11