Installation
Installing this product
Installation notes
•Do not install this product in places where it may become subject to high temperatures or humidity, such as:
*places close to a heater, vent or air conditioner.
*places exposed to direct sunlight, such as on top of the dashboard.
*places that may be splashed by rain, for example close to the door.
•Install this product in an area strong enough to bear its weight. Choose a position where this product can be firmly installed, and install it securely.
If this product is not securely installed, the current location of the vehicle cannot be dis- played correctly.
•Install this product horizontally on a surface within 0 degrees to 30 degrees tolerance. If the installation angles on the left and right sides exceed 5 degrees, the allowable range can be increased to 10 degrees by making corrective adjustments. (Refer to “Correcting the installation angle” in the “Operation Manual”.) If connection of the pink lead (CAR SPEED SIGNAL INPUT) is omitted, the angles on the left and right sides are allowable to within five degrees. Improper installation of the unit with the surface tilted more than these tolerances increases the potential for errors in the location display, and might oth- erwise cause reduced display performance.
If the angle exceeds five degrees, please make corrective adjustments.
•The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifiers and navigation mechanism to heat dissipate freely.
Do not cover this area.
•The semiconductor laser will be damaged if it overheats, so don’t install this product anywhere hot — for instance, near a heater outlet.
19