Digital Media AVIC-D1 installation manual Installing the GPS antenna, Installation notes

Page 24

Installation

Installing the GPS antenna

Do not cut the GPS antenna lead to shorten it or use an extension to make it longer. Altering the antenna cable could result in a short circuit or malfunc- tion and permanent damage to this product.

Installation notes

The antenna should be installed on a

level surface where radio waves will be blocked as little as possible. Radio waves cannot be received by the anten- na if reception from the satellite is blocked.

Installation on the vehicle roof or trunk lid is recommended to optimise recep- tion.

Roof

Trunk lid

Rear shelf

When installing the GPS antenna inside the vehicle, be sure to use the metal sheet pro- vided with your system. If this is not used, the reception sensitivity will be poor.

Do not cut the accessory metal sheet. This would reduce the sensitivity of the GPS antenna.

Take care not to pull the antenna lead when removing the GPS antenna. The magnet attached to the antenna is very powerful, and the lead may become detached.

The GPS antenna is installed with a magnet. When installing the GPS antenna, be care- ful not to scratch the vehicle body.

When installing the GPS antenna on the outside of the vehicle, always put it in the vehi- cle when going through an automatic vehicle wash. If it is left on the outside it may be knocked off and scratch the vehicle body.

Do not paint the GPS antenna, as this may affect its performance.

23

Image 24
Contents Installation Manual Important Information Contents Important Safeguards Connecting the System Before installing this product To prevent damageParts supplied Connecting the system See Page 9 toFrançais Italiano Connecting the power cord ON/OFFFor information on other leads See Pink CAR Speed Signal Input Español When connecting to separately sold power amp Front OutputDeutsch Français When connecting a Rear view camera Rear View CameraWhen connecting the external video component and the display When using a display connected to rear video outputInstallation Before installing To guard against electromagnetic interferenceInstalling this product Installation notesParts marked * are pre-installed DIN Front/Rear-mount DIN Front-mountDIN Rear-mount Installing the GPS antenna GPS antenna Metal sheet Clamp 5 pcs When installing the antenna outside the vehicle on the body When routing the lead in from the top of the doorAfter Installing this product Reconnecting the batteryInformation Importante Sommaire Importantes Mesures DEImportantes Mesures DE Securite Branchement du système Avant de raccorder ce produit Pour éviter des dégâtsPièces fournies Branchement du système Cf. Pages 9 àEnglish Branchement du cordon d’alimentation Noir masseEnglish Français Deutsch Français Rose CAR Speed Signal Input Violet/blanc Reversegear Signal Input NON-FADING Output Français Pour relier ce produit avec une caméra de rétrovisée Veillez à utiliser le cordon-rallonge fourni. L’utilisationPour relier l’appareil vidéo externe et l’affichage Pour utiliser un écran branché à la sortie vidéo arrièreInstallation Avant de procéder à l’installation Installation de ce produit Remarques sur l’installationLes pièces repérées * sont déjà montées sur ce produit Montage DIN avant/arrière Montage DIN avantMontage DIN arrière Installation de l’antenne GPS Français Deutsch Français Italiano Nederlands Cheminement du câble sur le haut de la portière Après installation de ce produit Branchement de la batteriePioneer Corporation