Digital Media AVIC-D1 installation manual GPS antenna Metal sheet Clamp 5 pcs

Page 25

Parts supplied

GPS antenna

Metal sheet

Clamp (5 pcs.)

Waterproof pad

When installing the antenna inside the vehicle (on the rear shelf)

Affix the metal sheet on as level a surface as possible where the GPS antenna faces the window. Place the GPS antenna on the metal sheet. (The GPS antenna is fastened with its magnet.)

Metal Sheet

GPS antenna Peel off the protective sheet

on the rear.

Make sure the surface is free of moisture, dust, grime, oil, etc., before affixing the metal sheet.

Note: The metal sheet contains a strong adhesive which may leave a mark on the surface if it is removed.

Clamps

Use clamps to secure the lead where necessary inside the vehicle.

Notes:

When attaching the metal sheet, do not cut it into small pieces.

Some models use window glass that does not allow signals from GPS satellites to pass through. On such models, install the GPS antenna on the outside of the vehicle.

English

Español

Deutsch Français Italiano

Nederlands

24

Image 25
Contents Installation Manual Important Information Contents Important Safeguards Connecting the System To prevent damage Before installing this productParts supplied See Page 9 to Connecting the systemFrançais Italiano ON/OFF Connecting the power cordFor information on other leads See Pink CAR Speed Signal Input Español Front Output When connecting to separately sold power ampDeutsch Français Rear View Camera When connecting a Rear view cameraWhen using a display connected to rear video output When connecting the external video component and the displayInstallation To guard against electromagnetic interference Before installingInstallation notes Installing this productParts marked * are pre-installed DIN Front-mount DIN Front/Rear-mountDIN Rear-mount Installing the GPS antenna GPS antenna Metal sheet Clamp 5 pcs When routing the lead in from the top of the door When installing the antenna outside the vehicle on the bodyReconnecting the battery After Installing this productInformation Importante Importantes Mesures DE SommaireImportantes Mesures DE Securite Branchement du système Pour éviter des dégâts Avant de raccorder ce produitPièces fournies Cf. Pages 9 à Branchement du systèmeEnglish Noir masse Branchement du cordon d’alimentationEnglish Français Deutsch Français Rose CAR Speed Signal Input Violet/blanc Reversegear Signal Input NON-FADING Output Français Veillez à utiliser le cordon-rallonge fourni. L’utilisation Pour relier ce produit avec une caméra de rétroviséePour utiliser un écran branché à la sortie vidéo arrière Pour relier l’appareil vidéo externe et l’affichageInstallation Avant de procéder à l’installation Remarques sur l’installation Installation de ce produitLes pièces repérées * sont déjà montées sur ce produit Montage DIN avant Montage DIN avant/arrièreMontage DIN arrière Installation de l’antenne GPS Français Deutsch Français Italiano Nederlands Cheminement du câble sur le haut de la portière Branchement de la batterie Après installation de ce produitPioneer Corporation