Black & Decker LPP120 Transporting Pole Saw, Assembly, Joining Saw Head Module to Handle Module

Transporting Pole Saw

• Always remove the battery pack from the 7 handle (figure 7) and cover the chain with the scabbard (figure 8) when transporting the Pole Saw. See page 8 for additional information on transporting the battery.

8

Assembly

Joining Saw Head Module to Handle Module

WARNING: Sharp moving blade. To prevent accidental operation, insure that battery is disconnected from the handle and that the protective scabbard is in place on the chain before performing the following operations. Failure to do this could result in serious personal injury.

The three modules which make up the Pole Saw are keyed to insure correct assembly. If a module does not smoothly attach to another do not force fit.

Combining the handle module (A) to the saw head module (C) creates a pole saw that is approximately 6 foot in length as shown in figure 9.

9

To attach the handle module to the saw head module:

1. Align the groove on the outside of the coupling end of the handle module (A) with the tongue on the inside of the coupling end of the saw head module (C). See figure 10. Push the two sections completely together.

2. Slide the threaded sleeve (6) figure 11
	10
on the saw head module down as far as
possible and rotate the sleeve clockwise
until it stops and completely covers the	Groove
orange threads as shown in figure 12.
WARNING: Always check to make
sure that the sleeve is completely	11
threaded on and that the orange
threads are no longer visible. Not
threading the sleeve completely on could
result in the modules becoming
disconnected creating a hazardous
condition. Periodically check the	12
connections to insure that no orange
threads are visible.

Joining Center Extension to Saw Head Module and Handle Module

Adding the extension (B) to the handle module (A) and saw head module (C) creates a Pole Saw that is approximately 9 foot in length as shown in figure 13.

13

To attach the middle module to the handle 14 module and saw head module:

1. Align the groove on the outside of the Groove coupling end of the handle module (A)

with the tongue on the inside of the

coupling end of the center extension 15

(B). See figure 14. Push the two sections completely together.

2. Slide the threaded sleeve (6) (figure

15) on the center extension down as

11