far as possible and rotate the sleeve |
|
16 | |
clockwise until it stops and completely |
|
covers the orange threads as shown in |
|
figure 16. |
|
3. Repeat steps 1 and 2 above to attach |
|
the saw head module to the center |
|
extension. |
|
WARNING: Always check to make sure that the sleeve is | |
completely threaded on and that the orange threads are no | |
longer visible. Not threading the sleeve completely on could result | |
in the modules becoming disconnected creating a hazardous | |
condition. Periodically check the connections to insure that no | |
orange threads are visible. |
|
Disassembly
Detaching Saw Head Module
WARNING: Sharp moving blade. To prevent 17 accidental operation, insure that battery is disconnected from the handle and that the protective scabbard is in place on the chain before performing the following operations.
Failure to do this could result in serious personal injury.
When detaching the modules, whether it is in the two module or three module mode, always detach the saw head module first. To do this, rest the handle
module on the ground and grasp the center of the saw head module with one hand figure 17. Use your other 18
hand to loosen the threaded sleeve figure 18 and then pull the two halves apart. Repeat this process if the center extension was attached.
Operating the Pole Saw
WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury.
Connecting the Battery
Place the battery in the tool as shown in figure 19 19 and be certain that it is inserted fully into the
tool cavity until it “clicks” into place. To remove the battery from the tool, press down on the release button on the back of the battery (figure 20) and slide out.
20
Switch
Always be sure of your footing and grip the Pole Saw firmly with both hands with the 21 thumb and fingers encircling the handle.
To turn the tool ON pull the lock button (1) back with your thumb and then squeeze the trigger (2) with your fingers as shown in figure 21. (Once the tool is running you can release the lock button.) To turn the tool OFF, release the trigger.
Auto-Stop Chain Braking System
Your chain saw is fitted with an
12