LUBRICATION
Replacing the engine oil
The engine oil should be changed the first time after 8 hours running time. It should then be changed after every 100 hours of running time.
WARNING!
Engine oil can be very hot if it is drained directly after stopping the engine. Allow the engine to cool somewhat first.
IMPORTANT INFORMATION
Avoid skin contact; wash with soap and water in case of spills.
1.Open the engine cover.
2.Place a container underneath the engine’s left oil
drain plug.
3.Remove the dipstick. Remove the drain plug from the engine’s left side.
4.Let the oil run out into the container.
IMPORTANT INFORMATION
Used engine oil is a health hazard and must not be disposed of on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location.
5.Then replace the oil drain plug and tighten it.
6.Replace the oil filter if necessary.
7.Fill with up to the “FULL” mark on the dipstick. Use engine oil as set out above.
8.Run the engine warm, then check that there is no leakage from the oil plug.