Husqvarna ProFlex 21 manual Service Journal, Service journal, Action, After the First 8 Hours

SERVICE JOURNAL

Service journal

Action

1.Delivery Service

2. Fill the battery with battery acid and charge for four hours.

3.Fit the steering wheel, seat and, where applicable, other components.

4. Attach the cutting unit.

5.Adjust the cutting unit:

Adjust the lifting springs (the “weight” of the cutting unit should be 12-15 kg, if a brush is to be used, set to maximum spring force).

Adjust the cutting unit so that its rear edge is about 2-4 mm higher than its front edge.

Adjust the cutting unit’s cutting height setting so that the cutting height limit is 5 mm above the unit frame at the lowest cutting height.

Check that the right amount of oil is in the engine and transmission.

6.	Check and adjust the air pressure in the tyres (60 kPa, 0.6 bar).
7.	Connect the battery.
8.	Fill the fuel tank and start the engine.
9.	Check that the machine does not move in neutral.
10.	Check:
	Driving forwards.
	Reversing.
	Engaging the blades.
	Safety switch in the seat.
	Safety switch for the lifting lever.
	The safety switch for the hydrostat pedals.
11.	Check the engine speed: 3,000 ±75 rpm.
12.	Bleed the hydraulic system (PF 21).
13.	Inform the customer about:
		Delivery service has been
14.	The need and advantages of following the service schedule.	carried out.
15.	The need and advantages of leaving the machine for service	No remaining remarks.
	every 300 hours.	Certified:

16.The effects of service and maintaining a service journal on the machine’s resale value.

17.Application areas for Mulching.

18.Fill in the sales papers, etc.

After the First 8 Hours

1. Change engine oil.

Date, mileage reading, stamp, signature

English-83