Husqvarna ProFlex 21 manual Throttle and choke cables, lever bearings

Page 69

LUBRICATION

9.Throttle and choke cables, lever bearings

PF 18

Remove the right side cover on the lever housing (3 screws) and open the engine cover. Lubricate the cables’ free ends with the oil can, even those by the carburettor. Move the controls to the end points and lubricate again.

Lubricate the joints, catches, and bearings for the cutting unit’s control levers with an oil can.

Note risk for incorrect assembly: The ﬁne threaded screw on the side cover should be ﬁtted from the outside.

Replace the lever housing’s side cover.

PF 21

Remove the right side cover on the lever housing (2 screws) and open the engine cover. Lubricate the cables’ free ends with the oil can, even those by the carburettor. Move the controls to the end points and lubricate again.

Lubricate the joints, catches, and bearings for the cutting unit’s control levers with an oil can.

Replace the lever housing’s side cover.

6020-050

PF 18

8009-157

PF 18

8009-349

PF 21

8009-178

PF 21

English-67

Image 69

Contents Rider ProFlex 18 Rider ProFlex Svenska Operator’s Manual for Rider ProFlex 18 and ProFlex ContentsImportant Information Introduction IntroductionSerial Number Proper ServiceSymbols and decals Explanation of SymbolsXxxxxxx xxxx xxxxxxxx xxx xxx xxxx xxxxxx Safety Instructions Safety instructionsGeneral use Keep children away from the work area Do not drive down slopes with the unit raised Do as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationPlacement of Controls Throttle Control Choke LeverAccelerator Accessories Lights and power outletCutting unit Lever for hydraulic lift of attachments, PF Cutting height adjustment leverLifting the cutting unit transport position Lowering the unit mowing positionMechanical lifting lever for cutting unit Transport positionMowing position Parking brake SeatFuelling Differential lock, PF Clutch controlChronometer Mowing tips DrivingBefore Starting DrivingStarting the engine Impaired cooling of the engine. Risk of major engine damageDo not run the starter motor for more than Driving the Rider, PF Stopping the engine, PF English-26 English-27 English-28 Maintenance MaintenanceMaintenance schedule = Described in this manual = Not described in this manual English-31 Engine cover Removing the Rider’s coversFront cover Right-hand wing coverLeft-hand wing cover Checking the engine’s cooling air intakeTransmission cover Checking the transmission air intake Cleaning the engine and mufﬂerChecking and adjusting the steering cables Checking and adjusting the throttle cable Checking and adjusting the choke cableAdjusting the differential lock, PF Cable holder Adjusting the hydrostatic transmission cablePoorly adjusted brake can result in reduced braking ability Adjusting the parking brakeReplacing the air ﬁlter, PF Replacing the air ﬁlterEnglish-40 English-41 Cleaning the pulse air ﬁlter Replacing the fuel ﬁlterChecking the fuel pump’s air ﬁlter Checking the tyre pressures Checking the battery acid levelIgnition system Wrong spark plug type can damage the engineReplacing the spark plug FusesChecking the safety system Replacing the light bulbs Cutting unit components Attaching the cutting unitExercise caution Risk of crush injuries Watch your ﬁngers. Do not turn the blades or the belt Check that the belt is around the idler Belt Sketch Parallelism Cutting heightPlacing in the service position Cutting unit’s service positionReleasing the service position Ground pressureChecking the blades Cutting unit modelExercise caution. Risk of crush injuries Removing the cutting unitPull out the unit so that it catches on the outer hooks Removing the belt Removing the unit frameHook the spring to the blade brake Attaching the beltChanging the cutting unit’s belt Removal of BioClip Plug Lubrication LubricationLubrication schedule, PF English-60 Lubricating the cables GeneralPedal mechanism in frame tunnel Lubricating in accordance with the lubrication scheduleDifferential lock cable, PF Chains in the frame tunnelOil is topped up through the hole the dipstick sits Engine oilReplacing the engine oil Gear lever TransmissionDriver’s seat Throttle and choke cables, lever bearings Oil ﬁlter, change Hydraulic oil ﬁlter, change, PFTransmission oil level Parking Brake CableEnglish-70 Trouble Shooting Trouble Shooting GuideProblem Cause English-72 Storage StorageWinter Storage Service Electrical system Electrical and Hydraulic SystemsEnglish-76 Hydraulic system, PF English-78 Technical data Technical DataData Rider ProFlex Hydraulic System TransmissionCutting unit Combi EU Declaration of Conformity EU Declaration of ConformityEU Declaration of Conformity only applies to Europe ProFlex 18 01/901/009 ProFlex 21 01/901/010English-82 Service journal Service JournalAction After the First 8 HoursAction Date, mileage reading, stamp Signature Hour Service English-85 English-86 English-87 English-88 Action Date, mileage reading, stamp, signature English-90 Svenska ´z+H6T¶68¨ Svenska 114 02