Husqvarna ProFlex 21 manual Safety Instructions, Safety instructions, General use

Page 9

SAFETY INSTRUCTIONS

Safety instructions

These instructions are for your safety. Read them carefully.

WARNING!

The inserted symbol means that important safety instructions needed to be observed. It applies to your safety.

General use

Read all instructions in this operator’s manual and on the machine before starting it. Ensure you understand them and then observe them.

Learn how to use the machine and its controls safely and learn how to stop quickly. Also learn to recognize the safety decals.

Only allow the machine to be used by adults who are familiar with its use.

Make sure nobody else is in the vicinity of the machine when you start the engine, engage the drive, or run the machine.

Clear the area of objects such as stones, toys, steel wire, etc. that may become caught in the blades and be thrown out.

Beware of the ejector and do not point it at any one.

Stop the engine and prevent it from starting before you clean the cutting unit.

Remember that the driver is responsible for dangers or accidents.

Never take passengers. The machine is only intended to be used by one person.

Always look down and behind before and during reversing manoeuvres. Keep watch for both large and small obstacles.

Slow down before turning.

Shut down the blades when not mowing.

Be careful when rounding fixed objects, so that the blades do not hit them. Never run the machine over foreign objects.

WARNING!

This machine can sever hands and feet as well as throw objects. Failure to observe the safety instructions can result in serious injuries.

8010-047

Read the operator’s manual before starting the machine

6003-002

Clear the area of objects before mowing

8010-052

Never take passengers

English-7

Image 9
Contents Rider ProFlex 18 Rider ProFlex Svenska Operator’s Manual for Rider ProFlex 18 and ProFlex ContentsImportant Information Introduction IntroductionSerial Number Proper ServiceSymbols and decals Explanation of SymbolsXxxxxxx xxxx xxxxxxxx xxx xxx xxxx xxxxxx Safety Instructions Safety instructionsGeneral use Keep children away from the work area Do not drive down slopes with the unit raised Do as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationPlacement of Controls Throttle Control Choke LeverAccelerator Accessories Lights and power outletCutting unit Lever for hydraulic lift of attachments, PF Cutting height adjustment leverLifting the cutting unit transport position Lowering the unit mowing positionMechanical lifting lever for cutting unit Transport positionMowing position Parking brake SeatFuelling Differential lock, PF Clutch controlChronometer Mowing tips DrivingBefore Starting DrivingStarting the engine Impaired cooling of the engine. Risk of major engine damageDo not run the starter motor for more than Driving the Rider, PF Stopping the engine, PF English-26 English-27 English-28 Maintenance MaintenanceMaintenance schedule = Described in this manual = Not described in this manual English-31 Engine cover Removing the Rider’s coversFront cover Right-hand wing coverLeft-hand wing cover Checking the engine’s cooling air intakeTransmission cover Checking the transmission air intake Cleaning the engine and mufflerChecking and adjusting the steering cables Checking and adjusting the throttle cable Checking and adjusting the choke cableAdjusting the differential lock, PF Cable holder Adjusting the hydrostatic transmission cablePoorly adjusted brake can result in reduced braking ability Adjusting the parking brakeReplacing the air filter, PF Replacing the air filterEnglish-40 English-41 Cleaning the pulse air filter Replacing the fuel filterChecking the fuel pump’s air filter Checking the tyre pressures Checking the battery acid levelIgnition system Wrong spark plug type can damage the engineReplacing the spark plug FusesChecking the safety system Replacing the light bulbs Cutting unit components Attaching the cutting unitExercise caution Risk of crush injuries Watch your fingers. Do not turn the blades or the belt Check that the belt is around the idler Belt Sketch Parallelism Cutting heightPlacing in the service position Cutting unit’s service positionReleasing the service position Ground pressureChecking the blades Cutting unit modelExercise caution. Risk of crush injuries Removing the cutting unitPull out the unit so that it catches on the outer hooks Removing the belt Removing the unit frameHook the spring to the blade brake Attaching the beltChanging the cutting unit’s belt Removal of BioClip Plug Lubrication LubricationLubrication schedule, PF English-60 Lubricating the cables GeneralPedal mechanism in frame tunnel Lubricating in accordance with the lubrication scheduleDifferential lock cable, PF Chains in the frame tunnelOil is topped up through the hole the dipstick sits Engine oilReplacing the engine oil Gear lever TransmissionDriver’s seat Throttle and choke cables, lever bearings Oil filter, change Hydraulic oil filter, change, PFTransmission oil level Parking Brake CableEnglish-70 Trouble Shooting Trouble Shooting GuideProblem Cause English-72 Storage StorageWinter Storage Service Electrical system Electrical and Hydraulic SystemsEnglish-76 Hydraulic system, PF English-78 Technical data Technical DataData Rider ProFlex Hydraulic System TransmissionCutting unit Combi EU Declaration of Conformity EU Declaration of ConformityEU Declaration of Conformity only applies to Europe ProFlex 18 01/901/009 ProFlex 21 01/901/010English-82 Service journal Service JournalAction After the First 8 HoursAction Date, mileage reading, stamp Signature Hour Service English-85 English-86 English-87 English-88 Action Date, mileage reading, stamp, signature English-90 Svenska ´z+H6T¶68¨ Svenska 114 02