Husqvarna ProFlex 21 manual English-88

Page 90

SERVICE JOURNAL

Action

Date, mileage reading, stamp,

 

signature

 

 

At Least Once Each Season

 

 

 

1. Change the engine oil (100 hours).

Notes

2.Clean/change the air cleaner’s pre-filter (Oil-foam element) (25 hours). (shorter intervals in dusty operating conditions)

3.Clean/change the air filter’s paper filter (100 hours). (shorter intervals in dusty operating conditions)

4.Clean the fuel pump’s air filter (50 hours).

5.Adjust the cutting height (50 hours).

6.Adjust the parking brake (50 hours).

7.Inspect the flame arrester/spark extinguisher, extra equipment (50 hours).

8.Replace the engine oil filter (200 hours).

9.Replace the hydraulic oil filter (200 hours).

10.Clean/change the spark plugs (100 hours).

11.Change the inline fuel filter (100 hours).

12.Clean the pulse air filter (100 hours).

13.Clean the cooling fins on the cylinders and cylinder head (100 hours).

(shorter intervals in dusty operating conditions)

14.Check the play on the engine valves (300 hours).

15.Change the oil and filter in gearbox K 62 or K66 (500 hours).

16.Perform the 300-hour service at an authorised service representative.

This field is intended for keeping a journal

English-88

Image 90
Contents Rider ProFlex 18 Rider ProFlex Svenska Contents Operator’s Manual for Rider ProFlex 18 and ProFlexImportant Information Introduction IntroductionProper Service Serial NumberExplanation of Symbols Symbols and decalsXxxxxxx xxxx xxxxxxxx xxx xxx xxxx xxxxxx Safety Instructions Safety instructionsGeneral use Keep children away from the work area Driving on slopes Do not drive down slopes with the unit raised Do as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationPlacement of Controls Throttle Control Choke LeverAccelerator Accessories Lights and power outletCutting unit Lifting the cutting unit transport position Cutting height adjustment leverLever for hydraulic lift of attachments, PF Lowering the unit mowing positionMechanical lifting lever for cutting unit Transport positionMowing position Parking brake SeatFuelling Differential lock, PF Clutch controlChronometer Driving Mowing tipsStarting the engine DrivingBefore Starting Impaired cooling of the engine. Risk of major engine damageDo not run the starter motor for more than Driving the Rider, PF Stopping the engine, PF English-26 English-27 English-28 Maintenance MaintenanceMaintenance schedule = Described in this manual = Not described in this manual English-31 Front cover Removing the Rider’s coversEngine cover Right-hand wing coverLeft-hand wing cover Checking the engine’s cooling air intakeTransmission cover Cleaning the engine and muffler Checking the transmission air intakeChecking and adjusting the steering cables Checking and adjusting the throttle cable Checking and adjusting the choke cableAdjusting the differential lock, PF Adjusting the hydrostatic transmission cable Cable holderAdjusting the parking brake Poorly adjusted brake can result in reduced braking abilityReplacing the air filter Replacing the air filter, PFEnglish-40 English-41 Cleaning the pulse air filter Replacing the fuel filterChecking the fuel pump’s air filter Ignition system Checking the battery acid levelChecking the tyre pressures Wrong spark plug type can damage the engineFuses Replacing the spark plugChecking the safety system Replacing the light bulbs Cutting unit components Attaching the cutting unitExercise caution Risk of crush injuries Watch your fingers. Do not turn the blades or the belt Check that the belt is around the idler Belt Sketch Cutting height ParallelismReleasing the service position Cutting unit’s service positionPlacing in the service position Ground pressureCutting unit model Checking the bladesRemoving the cutting unit Exercise caution. Risk of crush injuriesPull out the unit so that it catches on the outer hooks Removing the unit frame Removing the beltAttaching the belt Hook the spring to the blade brakeChanging the cutting unit’s belt Removal of BioClip Plug Lubrication LubricationLubrication schedule, PF English-60 General Lubricating the cablesLubricating in accordance with the lubrication schedule Pedal mechanism in frame tunnelChains in the frame tunnel Differential lock cable, PFEngine oil Oil is topped up through the hole the dipstick sitsReplacing the engine oil Gear lever TransmissionDriver’s seat Throttle and choke cables, lever bearings Hydraulic oil filter, change, PF Oil filter, changeParking Brake Cable Transmission oil levelEnglish-70 Trouble Shooting Trouble Shooting GuideProblem Cause English-72 Storage StorageWinter Storage Service Electrical and Hydraulic Systems Electrical systemEnglish-76 Hydraulic system, PF English-78 Technical Data Technical dataData Rider ProFlex Hydraulic System TransmissionCutting unit Combi EU Declaration of Conformity only applies to Europe EU Declaration of ConformityEU Declaration of Conformity ProFlex 18 01/901/009 ProFlex 21 01/901/010English-82 Action Service JournalService journal After the First 8 HoursAction Date, mileage reading, stamp Signature Hour Service English-85 English-86 English-87 English-88 Action Date, mileage reading, stamp, signature English-90 Svenska ´z+H6T¶68¨ Svenska 114 02