Samsung SCR-3000P 4ARCHIVE SETUP, Note, SLP, (5)CHANNEL, (2) VCR SPEED, (4)VCR BUZZER, (3)TAPE SELECT, (1) TAPE REC IF HDD TROUBLE, SCR-3000P(PAL, based on E-180)

DIGITAL VIDEO RECORDER

4ARCHIVE SETUP

The following illustration shows the initial settings of the ARCHIVE SETUP menu.

ARCHIVE SETUP

TAPE REC IF HDD TROUBLE EMG [O]

		FULL[X]
VCR SPEED		SP
TAPE SELECT		T-120
VCR BUZZER		OFF
CHANNEL		SELECT
CH 1:ON	CH 5:ON	CH 9:ON	CH13:ON
CH 2:ON	CH 6:ON	CH10:ON	CH14:ON
CH 3:ON	CH 7:ON	CH11:ON	CH15:ON
CH 4:ON	CH 8:ON	CH12:ON	CH16:ON

MOVE=[ /❷] SELECT=[ ] EXIT=[MENU]

(1) TAPE REC IF HDD TROUBLE

1)EMG

Set whether to allow the VCR to continue the recording if the hard drive fails for some rea- son. If there is a problem in HDD, it will automatically execute VCR BACKUP. If you replace the failed hard drive with a new one, VCR backup will be cancelled and the system will to the previous state, before the failure occurred. [O/X]

2)FULL

Set whether to allow the VCR to continue the recording if DISK END MODE is set to STOP. However, if DISK END MODE is set to OVERWRITE, this will be disabled. [O/X]

(2) VCR SPEED

Set the recording mode for the VCR. If you set this to SP, recording time will be shorter but picture quality will be better than setting it to SLP; and if you set this to SLP, recording time will be longer but picture quality will be poorer than setting it to SP.

●SCR-3000N/SSC-Dual [SP/SLP]

●SCR-3000P [SP/LP]

Note

- Recording Time to Recording Mode

	SP	SLP
SCR-3000N/SSC-Dual (NTSC, based on T-120)	2 Hours	6 Hours
	SP	LP
SCR-3000P (PAL, based on E-180)	3 Hours	6 Hours

(3)TAPE SELECT

Set the tape length for accurate calculation of remaining tape time and precise control.

●SCR-3000N/SSC-Dual [T-120/T-160/T180]

●SCR-3000P [E-180/E-210/E-260]

(4)VCR BUZZER

Set the buzzer so that the VCR's status could be known. If there is a problem in VCR SYS- TEM Set it to ON to enable the BUZZER and to OFF to disable the BUZZER.

The buzzer will sound in the following cases.: - If there is a problem in the VCR SYSTEM.

- If the tape reaches the end part or is in PRE END (when the remaining time is less than 5 minutes) during ARCHIVE.

- If there is no tape inserted, or REC Safety TAB is removed from the inserted tape when you start ARCHIVE, or in TIMER ARCHIVE MODE. [ON/OFF]

(5)CHANNEL

CHANNEL is enabled if MULTIPLEXER is set to WITH and disabled if it is set to WITH- OUT. If CHANNEL is enabled and you set it to SELECT, all channels recorded on the hard drive will be displayed. If you set it to ALL, all channels will be set to ON and become tar- gets for backup. [SELECT/ALL]

5-11 5-12