238 CHAPTER 16: IP ROUTING PROTOCOL OPERATION
■Setting the Interface Priority for DR Election
■Configuring the Peer
■Setting the Interval of Hello Packet Transmission
■Setting a Dead Timer for the Neighboring Routers
■Configuring an Interval Required for Sending LSU Packets
■Setting an Interval for LSA Retransmission between Neighboring Routers
■Setting a Shortest Path First (SPF) Calculation Interval for OSPF
■Configuring STUB Area of OSPF
■Configuring the NSSA of OSPF
■Configuring the Route Summarization of OSPF Area
■Configuring Summarization of Imported Routes by OSPF
■Configuring OSPF Virtual Link
■Configuring the OSPF Area to Support Packet Authentication
■Configuring OSPF Packet Authentication
■Configuring OSPF to Import Routes of Other Protocols
■Configuring Parameters for OSPF to Import External routes
■Configuring OSPF to Import the Default Route
■Setting OSPF Route Preference
■Configuring OSPF Route Filtering
■Configuring the Filling of the MTU Field When an Interface Transmits DD Packets
■Disabling the Interface to Send OSPF Packets
■Configuring OSPF and Network Management System (NMS)
■Resetting the OSPF Process
Enabling OSPF and Entering OSPF View
Perform the following configurations in System View.
By default, OSPF is not enabled.
When enabling OSPF, note the following:
■By default, the OSPF process ID is 1.
■If a router is running multiple OSPF processes, 3Com recommends that you to use
router-id in the command to specify different Router IDs for different processes.
Table221 Enabling the OSPF process
Operation Command
Enable the OSPF process ospf [ process_id [ router-id router_id ] ]
Disable the OSPF process undo ospf [ process_id ]