RSPAN Features 383
Configuration
Procedures in the SourceSwitch
Configuration
Procedures in theIntermediate Switch

Table404 Configuration procedures in the source switch

Operation Command Description
Enter system view system-view —
Establish Remote-probe
VLAN, and enter VLAN view
vlan vlan-id The parameter vlan-id represents
the ID of the Remote-probe VLAN.
Define the current VLAN as
Remote-probe VLAN
remote-probe vlan enable Required.
Exit the current view quit —
Enter the Ethernet port view
of Trunk ports
interface interface-type
interface-number
—
Configure Trunk ports so that
packets of the Remote-probe
VLAN can pass through
port trunk permit vlan
remote-probe-vlan-id
Required.
Exit the current view quit —
Configure the source group
of remote mirroring
mirroring-group group-id
remote-source
Required.
Configure the source ports of
remote mirroring
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
Required.
Configure the reflector ports
of remote mirroring
mirroring-group group-id
reflector-port reflector-port
Required.
The reflector ports of remote
mirroring cannot enable STP, and
have to be Access ports.
The reflector ports cannot have
the vlan-vpn commands
configured.
Configure the remote-probe
VLAN for the source group of
remote mirroring
mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id
Required.
Display the configuration for
the source group of remote
mirroring
display mirroring-group
remote-source
Optional.
The display command can be
used under any view.

Table405 Configuration procedures in the intermediate switch

Operation Command Description
Enter system view system-view —
Establish remote-probe VLAN,
and enter VLAN view
vlan vlan-id The parameter vlan-id
represents the ID of the
remote-probe VLAN.
Exit the current view quit —
Enter the Ethernet port view of
Trunk ports
interface interface-type
interface-number
—
Configure Trunk ports so that
packets in the remote-probe
VLAN can pass through
port trunk permit vlan
remote-probe-vlan-id
Required.
This configuration is necessary
for ports of intermediate
switch that are connected with
the source switch or the
destination switch.