Logging Function 473
3Sending the Information to monitor terminal4Sending the Information to log buffer.

Table526 Sending the Information to Log Buffer

5Sending the Information to trap buffer.

Table527 Sending the Information to Trap Buffer

Table525 Sending the Information to Monitor Terminal

Device Configuration Default Value Configuration Description
Switch Enable info-center By default,
info-center is
enabled.
Other configurations are valid only if the
info-center is enabled.
Set the information
output direction to
monitor
- -
Set information
source
-You can define which modules and
information to be sent out and the
time-stamp format of information, and so
on. You must turn on the Switch of the
corresponding module before defining
output debugging information.
Enable the terminal
display function and
this function for the
corresponding
information
-For Telnet terminal and dumb terminal, to
view the information, you must enable the
current terminal display function using the
terminal monitor command.
Device Configuration Default Value Configuration Description
Switch Enable info-center By default,
info-center is
enabled.
Other configurations are valid only if
the info-center is enabled.
Set the information output
direction to logbuffer
-You can configure the size of the log
buffer at the same time.
Set information source -You can define which modules and
information to be sent out and the
time-stamp format of information,
and so on. You must turn on the
Switch of the corresponding module
before defining output debugging
information.
Device Configuration Default Value Configuration Description
Switch Enable info-center By default, info-center
is enabled.
Other configurations are valid only if
the info-center is enabled.
Set the information
output direction to
trapbuffer
You can configure the size of the
trap buffer at the same time.
Set information source You can define which modules and
information to be sent out and the
time-stamp format of information,
and so on. You must turn on the
Switch of the corresponding module
before defining output debugging
information.