Logging Function 475
Table530 Configuring to Output Information to Loghost
Ensure to enter the correct IP address using the info-center loghost command to
configure loghost IP address. If you enter a loopback address, the system prompts of
invalid address appears.
3Configuring the information source on the Switch
With this command, you can define the information that is sent to the control
terminal, such as: generated by which modules, information type, information level,
and so on.
Perform the following operation in System View.
Figure125 Defining Information Source
modu-name specifies the module name; default represents all the modules; level
refers to the severity levels; severity specifies the severity level of information. The
information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to the loghost, channel-number or
channel-name must be set to the channel that corresponds to loghost direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there is
no specific configuration record for a module in the channel, use the default one.
If you want to view the debugging information of some modules on the Switch, you
must select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging Switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View:
Table531 Configuring the Output Format of Time-stamp
Operation Command
Output information to loghost info-center loghost host-ip-addr [ channel
{ channel-number | channel-name } ] [
facility local-number ] [ language {
chinese | english } ]
Cancel the configuration of
outputting information to loghost
undo info-center loghost host-ip-addr
Operation Command
Define information source info-center source { modu-name | default }
channel { channel-number | channel-name } [ { log
| trap | debug }* { level severity | state state
}* ]
Cancel the configuration of
information source
undo info-center source { modu-name | default }
channel { channel-number | channel-name }
Operation Command
Configure the output format of
the time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled undo info-center timestamp { log | trap |
debugging }