474 CHAPTER 22: FILE SYSTEM MANAGEMENT
6Sending the Information to SNMP

Table528 Sending the Information to SNMP

7Turn on/off the information synchronization Switch in Fabric

Figure124 Turn on/off the Information Synchronization Switch in Fabric

Sending the Informationto LoghostTo send information to the loghost, follow the steps below:1Enabling info-centerPerform the following operation in System View.

Table529 Enable/Disable Info-Center

Info-center is enabled by default. After info-center is enabled, system performances are affected when the system processes much information because of information classification and outputting.2Configuring to output information to loghostPerform the following operation in Table530.
Device Configuration Default value Configuration description
Switch Enable info-center By default,
info-center is
enabled.
Other configurations are valid only
if the info-center is enabled.
Set the information output
direction to SNMP
- -
Set information source -You can define which modules and
information to be sent out and the
time-stamp format of information,
and so on. You must turn on the
Switch of the corresponding
module before defining output
debugging information.
Configuring SNMP features -See RMON Configuration
Network
management
workstation
The same as the SNMP
configuration of the Switch
- -
Device Configuration Default Value Configuration Description
Switch Enable info-center By default, info-center is
enabled.
Other configurations are valid
only if the info-center is
enabled.
Set the information
output direction to
SNMP
By default, Switches of master
log in Fabric, debugging and trap
information synchronization are
turned on, so as log and strap
information synchronization
Switches in other Switches.
This configuration can keep
log information, debugging
information and trap
information in Fabric in every
Switch synchronized.
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable