SSH Terminal Services 515
Displaying and Debugging SSH
Run the display command in any view to view the running of SSH and further to
check configuration result.
Run the debugging command to debug the SSH.
Perform the following configurations in any view.
Table584 Display SSH Information
SSH Configuration
Example
Networking Requirements
As shown in Figure 143, configure a local connection from the SSH Client to the
Switch. The client uses SSH protocol to access the Switch.
Networking Diagram
Figure143 Networking for SSH Local Configuration
Configuration Procedure
1You should run this command before any other configuration:
[SW5500]rsa local-key-pair create
If you have configured local key pair in advance, this operation is unnecessary.
2For password authentication mode
[SW5500]user-interface vty 0 4
[SW5500-ui-vty0-4]authentication-mode scheme
[SW5500-ui-vty0-4]protocol inbound ssh
[SW5500]local-user client001
[SW5500-luser-client001]password simple 3com
[SW5500-luser-client001]service-type ssh
[SW5500]ssh user client001 authentication-type password
Select the default values for SSH authentication timeout value, retry value and update
interval of server key. Then run SSH1.5 client program on the PC which is connected
to the Switch and access the Switch using username “client001” and password
“3com”.
3For RSA authentication mode:
Create local user client002
[SW5500]local-user client002
Operation Command
Display host and server public keys display rsa local-key-pair public
Display client RSA public key display rsa peer-public-key [ brief | name
keyname ]
Display SSH state information and
session
display ssh server { status | session }
Display SSH user information display ssh user-information [ username ]
Enable SSH debugging debugging ssh server { VTY index | all }
Disable SSH debugging undo debugging ssh server { VTY index | all }
SSH Client Switch
SSH Client Switch