Installation and Setup (Continued)

3.Using a 10 mm combination wrench, remove the fasteners that secure each of the case sealer legs to the pallet as shown in Figure 2-3.

Figure 2-3—Remove Fasteners

6.Cut the plastic straps that attach the top head to the frame as shown in Figure 2-4. Retain the tool and spare parts kit for later use.

4.Remove the leg height adjustment cap screws and replace with the cap screws from the tool kit. Remove and replace them one at a time to keep the inner threaded plate in position.

5.Remove the machine from the pallet and move it into position.

Important: Whenever the machine is lifted with a fork truck, ensure that the forks span completely across the machine frame and do not contact any wiring or mechanism under the machine frame. In some cases, the lower taping head may need to be removed to avoid damage.

Figure 2-4—Cut the Plastic Straps

7.Assemble the column cap onto the column as shown in Figure 2-5.

8.Fasten the column setscrews as shown in Figure 2- 6.

WARNING

To reduce the risk associated with sharp blade hazards:

Keep hands and fingers away from tape cutoff blades under orange blade guards. The blades are extremely sharp.

Figure 2-5—Column Cap Setscrews

10

Page 18
Image 18
3M 10700, MN55144-1000 manual Remove Fasteners