Installation and Setup (Continued)
WARNING
•To reduce the risk associated with muscle strain:
−Use the appropriate rigging and material handling equipment when lifting or repositioning this equipment.
INFEED CONVEYOR ASSEMBLY
1.Remove the conveyor and the package of parts from the carton.
2.Verify that the package contains two flat plates, ten M8 x 20 hex socket head screws, and ten M8 flat washers.
3.To assemble the infeed conveyor, refer to Figure
4.Place the flat plates over the conveyor and the frame on each side and secure them with five M8
x20 screws and M8 washers.
5.Insert a M8 x 20 screw in each hole so that only
afew threads take hold.
Figure 2-2—Infeed Conveyor
CENTERINGGUIDES
1.Remove the two centering guides and four
M6 x 20 socket head screws from the package.
2.Using a 5 mm hex wrench, attach the centering guides to the rails with four M6 x 20 screws (two in each guide) as shown in
Figure
Figure 2-3—Centering Guides
11
