3M 10700, MN55144-1000 manual Box Drive Belt Tension Adjustment, Lower Belts Infeed End

Adjustments (Continued)

WARNING

•To reduce the risk associated with mechanical and electrical hazards:

−Turn electrical and air supply off and disconnect before performing any adjustments, maintenance, or servicing the machine or taping heads.

Refer to Figures 5-2 and 5-3 and adjust belt tension as follows:

1.Using a 17 mm open end wrench, loosen, but do not remove, the M10 lock nut. Refer to Figures 4-2 and 4-3.

2.Reset the tension on the drive belts as needed. Using a 6 mm long shank hex wrench (approximately 9 inches [230 mm] long), adjust the M8 tension screws in (clockwise) to increase tension or out (counterclockwise) to decrease tension.

3.Tighten the M10 lock nut to secure the tension setting.

Figure 5-2—Box Drive Belt Tension Adjustment, Lower Belts (Infeed End)

26