A&D AD-4212B-101/102/201/301, AD-4212A/B Confirming the coefficient, Setting the coefficient

15. PROGRAMMABLE-UNIT (AD-4212A only)

This is a programmable unit conversion function. It multiplies the weighing data in grams by an arbitrary coefficient set in the function table and displays the result.

The coefficient must be within the range between the minimum and maximum shown below. If the coefficient set is beyond the range, an error is displayed and the balance returns to the coefficient setting mode, prompting to enter an appropriate value. A coefficient of 1 was set at the factory.

Model	Minimum coefficient	Maximum coefficient
AD-4212A-100	0.000001	10000
AD-4212A-200/600/1000		1000

Operation

1 Press and hold the SAMPLE key until ba5fnc of the function table is displayed, then release the key.

2 Press the SAMPLE key several times to display

mlt

.

3 Press the PRINT key. The balance enters the mode to confirm or set the coefficient.

Confirming the coefficient

4 The current coefficient is displayed with the first digit blinking.

When it is not to be changed, press the CAL key and proceed to step 6. When it is to be changed, press the RE-ZERO key

and proceed to step 5.

Setting the coefficient

5 Set the coefficient using the following keys.

SAMPLE			key		To select a digit to change the
						value. The selected digit blinks.
				key	To change the value.
RE-ZERO
		key			To change the decimal point
MODE
						position.
					Each time the switch is pressed,
						the decimal point position
						changes as follows:
		key			To store the new setting, display
PRINT
							and go to step 6.
						end
	key				To cancel the new setting and go
CAL
						to step 6.

Selecting the programmable-unit ( )

6The balance displays Unit . Press the PRINT key to enter the unit selection mode. Select the programmable-unit ( ) as described in “5-2 Changing the Unit”.

7Press the CAL key to exit the programmable-unit function and return to the weighing mode.

Using the function

Perform weighing as described in “6-1 Basic Operation (Gram Mode)”. After weighing, the balance displays the result (weighing data in grams x coefficient).

62