A&D AD-4212B-101/102/201/301, AD-4212A/B Data Memory, Releasing Clr, Key until SClr no

14. DATA MEMORY

Data memory is a function to store weighing data or calibration data to display or output later. The data memory function can also store multiple upper/lower limit values or unit mass values, for later selection as necessary.

One of the following data sets can be stored:

Weighing data (Up to 200 sets. 100 sets when the time and date are added.)

Calibration and calibration test data (latest 50 sets)

Unit mass in the counting mode (Up to 20 sets)

Upper/lower limit values (Up to 20 sets)

Note

Data memory function is not available when the BCD output (OP-01) is installed.

14-1 Notes on Using Data Memory

To use the memory function, set the “Data memory ( data )” parameter of the function table. In addition, for weighing data, set the “Time/Date output (5-td)” parameter. For details on setting the data memory, refer to “10. FUNCTION TABLE”.

For weighing data, the data contents to be stored and the storage capacity depend on the “Time/Date output (5-td)” parameter setting.

Releasing “Clr”

If a different type of data exists in memory when the data is stored, “Clr” appears blinking in the upper left of the display. For example, you want to store weighing data but calibration data or unit mass data remains in memory.

Under such a condition, before storing data, delete the data in memory as follows:

1

Press and hold the

PRINT

key until

SClr no

with “no” blinking is displayed, then release the key.

2

Press the

key to display

with “go” blinking.

RE-ZERO

SClr go

The type of data stored in memory appears on the upper left of the display as shown below:

Unit mass in the counting mode

pC

Weighing data without time and date

-d-

Weighing data with time and date

d-t

Calibration or calibration test data

Hi5

Upper/lower limit values

Cp

3

Press the

key to delete all the data in memory.

PRINT

4 The balance displays

end

and returns to the weighing mode.

53