A&D EJ-3000, EJ-6100, EJ-440 Comparator, Func, Poff, Setting example, Selecting a comparison mode

6. COMPARATOR

The results of the comparison are indicated by HI, OK or LO on the display. The comparison is as follows:

LO < Lower limit value ≤ OK ≤ Upper limit value < HI

Operating conditions (see the function setting “Cp”):

‰No comparison (comparator function disabled).

‰Compares all data.

‰Compares all stable data.

‰Compares plus data except those near zero (plus data greater than +4d).

‰Compares stable plus data except those near zero (stable plus data greater than +4d).

‰Compares all data except those near zero (all data greater than +4d or less than -4d).

‰Compares stable data except those near zero (stable data greater than +4d or less than -4d).

d = the smallest display division. e.g.: 4d = four display divisions

The upper limit and lower limit numerical values are common to each of the weighing, counting and percent mode. The example for EJ-120/200/300/410/610 is as follows.

Upper limit value “001010”: “10.10g” “1010pcs” “101.0%”

Lower limit value “000990”: “9.90g” “990pcs” “99.0%”

6-1. Setting example

Press and hold

This example will be “Compares plus data except
those near zero”.	func
Selecting a comparison mode

1.

Press and hold the

SAMPLE

key to display

func

.

(If the comparison mode is already set, press the

SAMPLE

key to go to “Entering the upper and

lower limit

values”.)

2.

Press the

key, then the balance displays

PRINT

poff X

.

3.

Press the

key several times to display

SAMPLE

Cp

X

.

4.

Press the

key several times to display

RE-ZERO

Cp

3

.

5.

Press the

key to store the settings.

PRINT

Cp Hi

appears

after

end

.

poff 0

Press several times

Cp 0

Press several times

Cp 3

To store

12