A&D EJ-3000 Options, EJ-02 USB Interface, EJ-03 RS-232C serial interface, EJ-03 Installation

9. OPTIONS

The following options are available for the EJ series:

‰EJ-02 USB interface

‰EJ-03 RS-232C serial interface

‰EJ-07 Underhook for EJ-3000 / EJ-4100 / EJ-6100

‰EJ-08 Underhook for EJ-1500 / EJ-2000

‰EJ-11 Breeze break

‰EJ-12 Carrying case

‰EJ-13 Density Determination Kit for EJ-120 / EJ-200 / EJ-300 / EJ-410 / EJ-610

9-1. EJ-02 USB Interface

‰EJ-02 cannot be used together with EJ-03.

‰The EJ-02 is installed to the same slot as EJ-03 and see “9-2. EJ-03 RS-232C serial interface”.

‰The EJ-02 will be used to transmit the weight data (numerical value only) uni-directionally to a personal computer via USB.

‰The EJ-02 can transmit the weight data (numerical value only) directly to other application software such as Microsoft Excel, Word, memo pad, and so on.

‰The driver is not necessary to install.

‰The EJ-02 cannot be used for bidirectional communication.

9-2. EJ-03 RS-232C serial interface

This interface allows the EJ series to be connected with a multifunction printer or a personal computer.

‰EJ-03 cannot be used together with EJ-02.

‰The RS-232C interface has the following four modes.

Stream mode	Outputs data continuously.
Key mode	Outputs data by pressing the	PRINT	key.
Auto-print mode	Outputs data which meets the	conditions	of auto-print.
Command mode	Controls the balance using commands from a computer.

‰Set the parameters of the data format (bps and btpr) and data output mode (prt), as necessary.

‰Use a D-sub 9 pin cable (straight type) to connect with a computer. Optional cable: AX-KO2466-200 D-Sub 9 pin / 9 pin cable with 2 m long.

EJ-03 Installation

1.Turn off the balance and disconnect the AC adapter if used.

2.Remove the cover of the option slot on the rear by pressing and lowering it down.

3.Connect the connector in the slot to the EJ-03 unit and insert it into the slot.

Press and lower	Option slot for
down the cover.	EJ-02 / EJ-03

22