Chapter 2 Dual Phone System Integration
Changing Cisco Unity Administrator Settings
Caution Specify settings for the traditional phone system before specifying settings for Cisco CallManager. You must proceed in this order, or the integration may not work.
2.Specify settings for Cisco CallManager on the IP Switch page. For details, see the “To specify switch settings for Cisco CallManager” section on page
3.On the Ports page, assign port ranges to the traditional phone system first, then to CallManager, and adjust settings for the ports assigned to each phone system. For details, see the “To modify voice port settings” section on page
4.Select the phone system that subscribers and call handlers use. For details, see the “To select which phone system subscribers and call handlers use” section on page
5.Select the phone system that Cisco Unity uses when dialing out to send message notifications. For details, see the “To select which phone system Cisco Unity uses for message notification” section on page
Caution If you need to add or remove voice cards or uninstall the voice card software after the dual phone system integration is set up, you must also reinstall the
To specify switch settings for the traditional phone system
Step 1 Go to System > Switch > Switch. The settings for the traditional phone system selected during the Cisco Unity Setup program appear.
Step 2 In the Access Code field, enter the trunk access code that Cisco Unity must dial to transfer calls to Cisco CallManager from the traditional phone system.
The access code is the same number that subscribers on the traditional phone system dial to reach someone on the Cisco CallManager system.
| Siemens 9751 9006i DTMF Integration Guide |
