11
Chapter 2 - Hardware Installation
Introduction
This chapter details the contents of the MTA128ST-USB shipping container, describes each cable
connection, and describes the LED indicators.
Unpacking Your MTA128ST -USB
The shipping box contains the MTA128ST-USB, an external power supply, one RJ-45 line cord, one
USB cable, your Quick Start Guide, and three diskettes (i.e., MTA128ST-USB User Guide,
MTA128ST-USB Driver Software, and ISDN Configuration Utility). Inspect the contents for signs of
any shipping damage. If damage is observed, do not power up the unit; contact Multi-Tech’s
Technical Support for advice (refer to Chapter 6). If no damage is observed, place the MTA128ST-
USB in its final location and refer to “Assembling the MTA128ST-USB” in the next section.
MADE IN U.S.A
MADE IN U.S.A
Quick Start Guide
Four USB V.90 Modems
TD RD LS B1 B2 TR OH 128 P1 P2
USB ISDN Modem with Analog Port
Figure 2-1. Unpacking
Safety Warning Telecom/ISDN-ST
1. Never install telephone wiring during a lighting storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
3. This product is to be used with CE approved/marked computers.
4. Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
5. Use caution when installing or modifying telephone lines.
6. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a
remote risk of electrical shock from lightning.
7. Do not use the telephone to report a gas leak in the vicinity of the leak.
8. To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
9. If S/T - interface ISDN network connection cable is used, the ISDN phone cord
should be connected between the ISDN network connection cable and a NT1 device.