Set Up the LAN
If you are operating in Router mode and in a LAN environment, then you also need to set your LAN protocol, Ethernet Port IP address, and subnet mask.
If you prefer, you may use the default values of 10.0.0.1 for the Ethernet Port IP Address, and 255.255.255.0 for the subnet mask.
1From the System Management main menu (page 102), enter 2 to display the LAN Configuration menu.
2Configure the following parameters, 1 through 6, for the PPP session:
LAN Protocol
Enter 1 then select one of the following for DHCP protocol:
•
If a DHCP server is not set up and active on your LAN, do not enable DHCP client. DHCP Client mode is recommended for use only when bridging is used as the LAN protocol.
•
104 | MM701G and MM702G User Manual |