Chapter 7: Implementing a Point-to-Point LAN Extension

Configure the Remote LAN

1Select LAN on the menu bar, then select LAN Setup under LAN Options] to access the LAN Configuration page.

2In the LAN Protocol box, confirm that the protocol is set to Bridged. If the protocol is not set to bridged, it can be changed only through the command-line interface. See Appendix A, “Accessing the Command-Line Interface” for procedures on using this interface to change the LAN protocol.

Any device (such as a PC) connecting to the modem LAN interface loses its connection when the modem LAN IP address is changed. After the IP address is changed, you need to specify this new address in the Web browser to reconnect a device.

3In the IP Address box, enter an available IP address on your subnet.

4Click Apply.

MM701G and MM702G User Manual

69