
Configure NAT
CONFIGURE NATNAT provides the ability to map private IP address on the LAN to | System | |
public IP addresses (WAN) that are assigned to each session. |
|
|
|
| |
|
| |
This essentially hides the private IP addresses behind the public | SmartCNCTSecurity | |
IP addresses assigned to WAN sessions. Prior to binding NAT to a |
|
|
WAN IP address, you should have previously set up PPPoA routed, PPPoE routed, or RFC 1483 routed WAN sessions (see “Configure a New WAN Session” on page 26). You cannot configure NAT for RFC 1483 bridged sessions.
1Select System on the menu bar, then select SmartCNCTSecurity under [Configuration] to access the Security Interface Configuration page.
78 | MM701G and MM702G User Manual |