1. Introduction
The operating instructions below serve only as an addition to be used in conjunction with the operating instructions of the AEG Power Solutions
1.1 General
The Ethernet bus module can connect up to 8 power controllers of type
Several bus modules can be used on one system.
The power supply of the bus module comes from an external 24V DC voltage source (150mA), which is to be fed in (reverse polarity protected) at X11.1 (+) and X11.2 (ground). Several modules can be operated from one power supply.
As short a ground connection as possible is needed at terminal X11.3 for EMC reasons.
1.2Special features
•The Ethernet bus module connects the devices with several Ethernet bus systems. By setting the “Protocol” switch to 0, the Ethernet bus module becomes a ProfiNet
•function control via LED
•8 free application outputs X1 to X8 in each case terminal 5
•
1.3Type designation
Ethernet bus module ProfiNet
1.4 Abbreviations
AEG PS | AEG Power Solutions GmbH |
TPM | Thyro – Power Manager |
TSC | Thyro – Step Controller |
TMU | Thyro – Measurement Unit |
TIO | Thyro Input / Output Unit |
1.5 Warranty
In the event of any claims in connection with the Ethernet bus module, please contact us quoting:
•type designation
•fabrication number / serial number
•reason for the complaint
•environmental conditions of the device
•operating mode
•period of use
Goods and services are subject to the general conditions of supply for products of the electrical industry, and our general sales conditions. Claims in connection with supplied goods must be submitted within one week of receipt, along with the delivery note. AEG PS will rescind all obligations such as warranty agreements, service contracts, etc. entered into by AEG PS or its representatives without prior notice if maintenance and repair work is carried out using anything other than original AEG PS spare parts or spare parts purchased from AEG PS.
5
