Agilent Technologies 6287 manual Ultra Connection to Printer/Plotter

Page 2-6 6287 ULTRA User’s Manual

6287 ULTRA Connection to Printer/Plotter

Insert the DEVICE end of the AGILE printer cable into the connector on the rear of the printer. Then connect the IC+/ULTRA end of the AGILE printer cable to the output port of the ULTRA. Secure the cable to the printer using the clips (parallel) or screws (serial) provided. The FCC requires all printer interface cables to be properly shielded.

OUTPUT	ALTERNATE HOST INPUT	CONTROLLER
SERIAL AND PARALLEL	SERIAL AND PARALLEL	COAX
	A	B

ON

1 2 3 4 5 6 7 8

OFF

ON

ON

1 2 3 4 5 6 7 8

117 VAC	50/60 Hz	FUSE
.5A	35W	250V-1.0A
		SLO BLO

LISTED

U®L

CAUTION-FOR CONTINUED PROTECTION

AGAINST FIRE, REPLACE ONLY WITH

SAME TYPE AND RATING OF FUSE ®

RG 62 A/U

MODEL 6287 ULTRA

S/N 00000

This equipment complies with the requirements in Part 15 of FCC Rules for a Class A computing device. Operation of this equipment in a residential area may cause unacceptable interference to radio and TV reception requiring the operator to take whatever steps are necessary to correct the interference.

LR 69521 E.D.P. EQUIPMENT Y 47T8