Agilent Technologies 8922 Loading and Running the Ram Test

2-7
Running Diagnostics
Loading and Running the Ram Test
Loading and Running the Ram Test
Your HP/Agilent 8922B comes with software to test the Data Buffer.
Loading the RAM Test
1Locate the floppy disk labeled “08922-10001, 8922B Driver.”
2Insert the disk into the drive.
3TypeMSI A: (substitute your drive specifier for A: if your drive is not drive A) and
press .
4TypeLOAD “DRIVER22B”,1 and press .
The Data Buffer Driver will now be loaded and will begin to run.
5Press
6Use the cursor to select the output device.
7Select the area of RAM to test and Press .
8Repeat selection for each area of RAM.
Where to go next
• If any of the RAM areas tested bad go to chapters 8 and 9.
Selecting from a List
• Use and toscroll through the list. A beep will sound when you reach an end
of the list.
• Use or to move to the first item in the list.
• Use or to move to the last item in the list.
• Use or to select the current item and move to the next field on the
screen.
• Use to select the current item and move to the previous field on the screen.
ENTER
ENTER
K3, "Test RAM
K0, "Accept
⇓
⇓
SHIFT
⇓
PG UP
SHIFT ⇓PG DOWN
ENTER
⇓
⇓