8-7
Assembly and Disassembly Procedures

A1 Front Panel Removal

A1 Front Panel Removal
Done with top, bottom, and inside protective covers removed.
Removing Modules
1. Remove RF cover.
2. Remove RF modules.
Disconnecting Cables
3. Disconnect RF cable on mixer assembly. (1/4-inch SMA connector)
4. Disconnect cable from connector J77 on motherboard.
5. Disconnect top cable from pulse switch.
6. Disconnect cable from connector J6 on motherboard.
7. Disconnect cable from connector J5 on motherboard.
8. Disconnect ribbon cable from front panel.
Detaching Front Panel
9. Remove TX-15 top CRT mounting screw.
10.Remove 2 TX-15 side CRT mounting screws.
11.Remove 8 TX-10 front panel mounting screws. (both sides)
NOTE Steps 12 and 13 are necessary only when complete removal of the front panel is desired.
Most repairs can be made without completing these steps.
12.Remove 15 5/8-inch hex nuts.
13.Pull front panelassembly away from chassis until speaker assembly is visible. Remove
3 TX-10 mounting screws and disconnect the speaker cable from J7 on motherboard.
Tools Required
TX-15 screw driver
TX-10 screw driver
2-pt. Pozidriv
5/8-inch wrench
1/4-inch wrench