Allied Telesis AT-2972SX, AT-2916SX, AT2972SX/2 manual Creating a Team Using the Wizard

Creating a Team Using the Wizard

Advanced Control Suite User’s Guide

ˆLink Aggregation. In this type of team, you can dynamically configure the network adapters that have been selected to participate in a given team. If the link partner is not correctly configured for IEEE 802.3ad link configuration, errors are detected and noted. All adapters in the team are configured to receive packets for the same MAC address. The outbound load balancing scheme is determined by the BASP driver. The team’s link partner determines the load balancing scheme for inbound packets. In this mode, at least one of the link partners must be in active mode.

ˆGeneric Trunking. This type of team is very similar to the Link Aggregation type in that all of the adapters in the team need to be configured to receive packets for the same MAC address. However, this mode, does not provide Link Aggregation Control Protocol (LACP) or marker protocol support. This mode supports a variety of environments where the link partners are statically configured to support a proprietary trunking mechanism. Generic trunking supports load balancing and failover for both outbound and inbound traffic.

ˆSLB (Auto-Fallback Disable). This team is identical to Smart Load Balance and Failover, with the following exception—when the standby member is active, if a primary member comes back on line, the team continues using the standby member instead of switching to the primary member. This type of team is supported only for situations in which the network cable is disconnected and reconnected to the network adapter. It is not supported when the adapter is removed or installed via the Device Manager or a Hot-Plug PCI application.

To create a team using the wizard, perform the following procedure.

1. From the Tools menu, click Create a Team.

43