Spanning Tree Commands

get-st-bcfg

This command retrieves the Spanning Tree bridge parameters. If

Spanning Tree is disabled, no parameters will be retrieved.

get-st-pcfg

This command retrieves the Spanning Tree port parameter table. If

Spanning Tree is disabled, no parameters will be retrieved.

get-st-syscfg

This command retrieves the Spanning Tree state of all the ports.

set-br-prio

This command sets the Spanning Tree bridge priority of the Switch. priority is an integer in the range 0..65535.

set-br-prio <priority>

set-br-maxage

set-br-maxage <maxage>

This command sets the Spanning Tree bridge MaxAge. This is the amount of time between Spanning Tree configuration messages. Note that maxage is in units of seconds in the range 6..40.

set-br-hellot

set-br-hellot <hello_time>

This command sets the Spanning Tree bridge Hello Time. hello_time is an integer in the range 1..10. Note that hello_time is in units of seconds.

set-br-fwdel

set-br-fwdel <forward_delay>

This command sets the Spanning Tree bridge Forward Delay. This controls the amount of time between the listening and forwarding Spanning Tree states, and is completely unrelated to the forwarding latency. Note that forward_delay is an integer in units of seconds in the range 4..30.

14-2

Page 70
Image 70
Allied Telesis at-8116 Get-st-bcfg, Get-st-pcfg, Get-st-syscfg, Set-br-prio, Set-br-maxage, Set-br-hellot, Set-br-fwdel