Allied Telesis at-8116 manual Table C-7Port Configuration Commands, Table C-9Spanning Tree Commands

		AT-8116 User’s Guide
	Table C-7Port Configuration Commands
get-port-cfg		Display the configuration of all ports
set-port-dplex		Set the port mode: full or half duplex
set-speed-sel		Set the port speed : 10Mbps, 100Mbps or Asense
set-port-state		Enable or disable a port when Spanning Tree algorithm
		is not running
set-aggr-mode		Enable or disable switch aggressive mode
	Table C-8Switching Statistics Commands
clr-cnt		Clear the switch Ethernet and bridging counters
get-eth-cnt		Get the Ethernet counters per port
get-colls-cnt		Get the collision distribution counters per port
get-rmon-cnt		Get the Ethernet RMON counters per port
get-sdist-cnt		Get packet size distribution counters per port
get-mgm-brcnt		Get the switching counters of the mgmt port
	Table C-9Spanning Tree Commands
get-stp		Display the Spanning Tree session state
set-stp		Enable/Disable Spanning Tree - for the next session
get-st-bcfg		Retrieve the Spanning Tree Bridge parameters
get-st-pcfg		Retrieve the Spanning Tree port parameter table
get-st-syscfg		Retrieve the Spanning Tree System Ports configuration
set-br-prio		Set the Spanning Tree bridge priority
set-br-maxage		Set the Spanning Tree bridge MaxAge
set-br-hellot		Set the Spanning Tree bridge HelloTime
set-br-fwdel		Set the Spanning Tree bridge Forward Delay
set-prt-prio		Set the Spanning Tree port priority
set-br-enb		Set the Spanning Tree port enable/disable
set-br-pcost		Set the Spanning Tree port path cost

C-5