Printing on Back Print Film

2.Roll up both sheets together with an approximate diam- eter of 1 inch to resist the curl.

Plain paper (paper for copiers)

Curled sheet with a transferred image facing up

Approximate diameter of 1 in / 25 mm

3.Leave them rolled up for five minutes.

Approximate diameter of 1 in / 25 mm

4.Unroll them, and the curl should be corrected.

Note

Do not leave the back print film attached to the transfer sheet too long after the transfer. Doing so will make the sheet get curled up more tightly.

Now you have an image with glossy finish.

Step 7¨ Obtain a Matte Finish

If you want to create a matte finish, perform the following steps after completing the steps for making a glossy finish.

1.Place the matte finishing sheet on the image side of the paper with the silicon coated side face down (so that the cut corner is in the lower left corner).

Matte Finishing Sheet

Paper with the back

 

print image

Paper with the back

Matte Finishing Sheet

print image

 

111

Page 113
Image 113
Alps Electric MD-1300 manual 111, ¨ Obtain a Matte Finish, Leave them rolled up for five minutes