Chapter 2 - Various Printing Operations

3.Remove the iron-on transfer sheet after the cloth has cooled completely.

Starting at the corners, make sure the iron-on is firmly attached to the cloth, and then carefully peel off the rest of the sheet. If the sheet does not come off cleanly, replace it, and then iron it again.

4.Place the finishing sheet on the cloth with the silicon coated side face down (with the cut corner in the upper left corner). Apply the iron again to completely affix the iron-on to the cloth.

Finishing Sheet

Cloth the iron-on was transferred to

Note

The finishing sheet can be used many times. Do not discard it after using it.

5.Remove the finishing sheet after the cloth has cooled com- pletely.

Caution

The iron-on should withstand many washings but if it should begin to peel away again for some reason simply use the finishing sheet again to reattach it.

Do not use dry cleaning. Also, the transferred image may peel off in the laundry if the cloth stretches or shrinks a lot, does not withstand heat well, or if the cloth has a nap. These kinds of cloth should be avoided.

Note that once an iron-on has been applied it cannot be re- moved.

Do not use bleach. Bleach may cause the colors in the printed image to run.

Do not use the iron directly on the iron-on.

Do not dry in a dryer.

118

Page 120
Image 120
Alps Electric MD-1300 manual 118