Alps Electric manual Click on the MD-1300 printer driver icon

Chapter 1 – Major Functions and Operations

2.Click on the MD-1300 printer driver icon.

The box on the right displays the SCSI device number of the

MD-1300. (A)

Make sure that the line indicated by (A) is highlighted. If it is not, your printer is not being recognized properly. Click on the line (A) a few times. If it is still not highlighted, it is possible that the Finder has insufficient memory. In this case, close the Chooser, run any one of your application programs, and se- lect the printer from the Chooser again.

3.If you have several MD-1300 printers connected, click on the SCSI device number of the printer you will use.

The factory device setting is #6. To change SCSI device num- bers, refer to “Specifications” in Appendix.

Note

If you have two SCSI busses in your Macintosh, “SCSI #6 BUS #1” or similar will be displayed.

Note

Immediately following installation, background printing is turned off. Click on the On button to enable background printing. Back- ground printing will not be available if you did not install the Queue Kit software.

4.Click on the close box to close the Chooser.

When the selected printer driver is changed from some other printer driver to the MD-1300 printer driver, a dialog box will appear to inform you that a different printer has been selected.

5.Click on the OK button to close the dialog box.

32