140 Operation
Chapter 5 - Command Line Interface
5.4.3 exit

This command returns to the Exec mode or exits the configuration program.

Default Setting
None
Command Mode
Any
Example

This example shows how to return to the Exec mode from the Interface

Configuration mode, and then quit the CLI session:

5.4.4 ping

This command sends ICMP echo request packets to another node on the network.

Syntax
ping <host_name | ip_address>
•host_name - Alias of the host.
•ip_address - IP address of the host.
Default Setting
None
Command Mode
Exec
Command Usage
• Use the ping command to see if another site on the network can be reached.
• The following are some results of the ping command:
-Normal response - The normal response occurs in one to ten seconds, depending on network
traffic.
-Destination does not respond - If the host does not respond, a “timeout” appears in ten
seconds.
-Destination unreachable - The gateway for this destination indicates that the destination is
unreachable.
-Network or host unreachable - The gateway found no corresponding entry in the route table.
• Press <Esc> to stop pinging.
Enterprise AP(if-ethernet)#exit
Enterprise AP#exit
CLI session with the Access Point is now closed
Username: