VLAN Commands
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 247
5.23 VLAN Commands
The AP can enable the support of VLAN-tagged traffic passing between wireless
clients and the wired network. Up to 64 VLAN IDs can be mapped to specific
wireless clients, allowing users to remain within the same VLAN as they move
around a campus site.
When VLAN is enabled on the AP, a VLAN ID (a number between 1 and 4094) can
be assigned to each client after successful authentication using IEEE 802.1X and
a central RADIUS server. The user VLAN IDs must be configured on the RADIUS
server for each user authorized to access the network. If a user does not have a
configured VLAN ID, the AP assigns the user to its own configured native VLAN
ID.
The VLAN commands supported by the AP are listed below.

5.23.1 vlan

This command enables VLANs for all traffic. Use the no form to disable VLANs.
Syntax
[no] vlan enable
Default
Disabled
Command Mode
Global Configuration
Command Description
• When VLANs are enabled, the AP tags frames received from wireless clients with the VLAN ID
configured for each client on the RADIUS server. If the VLAN ID has not been configured for a
CAUTION
When VLANs are enabled, the AP’s Ethernet port drops all received traffic that does not include a
VLAN tag. To maintain network connectivity to the AP and wireless clients, be sure that the AP is
connected to a device port on a wired network that supports IEEE 802.1Q VLAN tags.
Table 5-21: VLAN Commands
Command Function Mode Page
vlan Enables a single VLAN for all traffic GC 247
management-
vlanid
Configures the management VLAN for the AP GC 248
vlan-id Configures the default VLAN for the VAP interface IC-W-VA
P
248