System Logging Commands
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 161
5.6 System Logging Commands
These commands are used to configure system logging on the AP.

5.6.1 logging on

This command controls logging of error messages; i.e., sending debug or error
messages to memory. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to memory. You can use the logging level
command to control the type of error messages that are stored in memory.
Example

5.6.2 logging host

This command specifies syslog servers host that will receive logging messages.
Use the no form to remove syslog server host.
Table 5-7: System Logging Commands
Command Function Mode Page
logging on Controls logging of error messages GC 161
logging host Adds a syslog server host IP address that will receive
logging messages
GC 161
logging console Initiates logging of error messages to the console GC 162
logging level Defines the minimum severity level for event logging GC 162
logging facility-type Sets the facility type for remote logging of syslog messages GC 163
logging clear Clears all log entries in AP memory GC 164
show logging Displays the state of logging Exec 164
show event-log Displays all log entries in AP memory Exec 165
Enterprise AP(config)#logging on
Enterprise AP(config)#