Advanced Configuration
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 63
Disabled: Allows management access from wireless clients.
Enabled: Blocks management access from wireless clients.
Uplink Port MAC Address Filtering Status – Prevents traffic with specified source
MAC addresses from being forwarded to wireless clients through the AP. You can
add a maximum of four MAC addresses to the filter table. (Default: Disabled)
MAC Address: Specifies a MAC address to filter, in the form xx-xx-xx-xx-xx-xx.
Permission: Adds or deletes a MAC address from the filtering table.
Ethernet Type Filter – Controls checks on the Ethernet type of all incoming and
outgoing Ethernet packets against the protocol filtering table. (Default: Disabled)
Disabled: AP does not filter Ethernet protocol types.
Enabled: AP filters Ethernet protocol types based on the configuration of
protocol types in the filter table. If the status of a protocol is set to ON, the
protocol is filtered from the AP.
Ethernet Type Filter – Enables or disables Ethernet filtering on the port. (Default:
Disabled)
4.4.6.0.1 CLI Commands for Bridge Filtering Use the filter local-bridge command from the global configuration mode to
prevent wireless-to-wireless communications through the AP. Use the filter
ap-manage command to restrict management access from wireless clients. To
configure Ethernet protocol filtering, use the filter ethernet-type enable
command to enable filtering and the filter ethernet-type protocol command to
define the protocols that you want to filter. To remove an entry from the table, use
the address filter delete command. To display the current settings, use the show
filters command from the Exec mode.
NOTE
Ethernet protocol types not listed in the filtering table are always forwarded by the AP.