Installation
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 19
2.3 Installation
The following sections describe how to install a Wi² unit, including attaching the
SU-ODU to the mounting plate, attaching the mounting plate to the Wi² unit,
connecting to the SU-ODU, pole mounting, connecting a grounding cable, and
connecting the antenna(s).

2.3.1 Attaching the SU-ODU to the Mounting Plate

1Determine the tilt direction of the SU-ODU.
2Using the M8 x 16 hex head screws and the flat washers and spring washers
supplied, attach the SU-ODU to the mounting plate as shown in Figure 2-5 in
the direction marked.
3Tighten the screws. Apply torque of 57 lb*in [6.4 N*m].
IMPORTANT
The angle at which the SU-ODU is mounted on the Wi² can be adapted depending on the location
of the Wi² unit in relation to the Base Station. Once attached, the mounting plate can be tilted either
up or down. Before attaching the SU-ODU to the mounting plate, determine the direction of the tilt.
To attach a BreezeMAX PRO-S ODU or BreezeACCESSSU-ODU with HW Revision E
(octagonal) to the mounting plate:
NOTE
BreezeACCESS SU-ODU with HW Revision E is the new, smaller, octagonal ODU available in the
5.4 and 5.8 GHz bands. BreezeACCESS SU-ODUs with HW Revision D or lower are rectangular
and slightly larger in size.