Installation
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 25
2.3.3.3 Connecting to BreezeACCESS ODU with HW Revision E
1Adapt the cable as described in Section 2.3.3.2
2 Connect the cable to the ODU as described in Section 2.3.3.1.
2.3.3.4 Connecting to BreezeACCESS ODU with HW Revision D or Lower
1Cut the cable as close as possible to the connector that should be connected to
the ODU (the end without the service box).
2Route the cable through the service box supplied with the SU-ODU.
3Connect the spare RJ-45 connector, supplied with the cable kit, as described
in step 2 of Section 2.3.3.2
4Connect the Ethernet cable to the SU-ODU RJ-45 connector.
5Make sure that the external jacket of the cable is well inside the service box to
guarantee a good seal.
6Verify that the O-ring of the service box kit is in place, attach the service box to
the unit and tighten the top nut.
7Connect the other end of the cable to the SU port on the Wi² unit.
8Make sure that the external jacket of the cable is well inside the service box to
guarantee a good seal. Verify that the O-ring supplied with the service box is in
place, attach the service box to the unit and tighten the top nut.
Table 2-3: Cable Color Codes
Wire color Pin
Blue 1
Blue/white 2
Orange 3
Orange/white 6
Brown 4
Brown/white 5
Green 7
Green/white 8