Advanced Configuration
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 61

4.4.5.0.3 CLI Command for 802.1x Supplicant

To configure the AP to operate as a 802.1X supplicant, first use the 802.1X
supplicant user command to set a user name and password for the AP, then use
the 802.1X supplicant command to enable the feature. To display the current
settings, use the show authentication command from the Exec mode (not shown
in the following example)
4.4.6 Filter Control
The AP can employ network traffic frame filtering to control access to network
resources and increase security. You can prevent communications between
wireless clients and prevent AP management from wireless clients. You can also
block specific Ethernet traffic from being forwarded by the AP.
Enterprise AP(config)#mac-authentication server remote 200
Enterprise AP(config)#mac-authentication
session-timeout 300 200
Enterprise AP(config)#exit
Enterprise AP#show authentication 197
Authentication Information
===========================================================
MAC Authentication Server : REMOTE
MAC Auth Session Timeout Value : 300 min
802.1x supplicant : DISABLED
802.1x supplicant user : EMPTY
802.1x supplicant password : EMPTY
Address Filtering : DENIED
System Default : DENY addresses not found in filter table.
Filter Table
MAC Address Status
----------------- ----------
00-70-50-cc-99-1a DENIED
00-70-50-cc-99-1b ALLOWED
=========================================================
Enterprise AP#
Enterprise AP(config)#802.1X supplicant user secureAP dot1xpass 196
Enterprise AP(config)#802.1X supplicant 196
Enterprise AP(config)#